PrintrBot Power Tower - revised
Description
This Is To Be Made Using "1/4In" Plywood (0.210 - 0.235In). Full Build Guide Of The Original Http://Help.Printrbot.Com/Guide/Power+Tower+With+Spool+Rack+%28New+Model%29/146 . It Is Laid Out To Be Laser Cut From A 12 X 24In Sheet, The Other File Is For The Two Smaller Panels For Back Lighting Of The Gear (Gear Can Be Changed For What Ever You Want !). I Trimed The Power Wires Leaving The Pci-E For Printer And Molex For Future. I Also Left 2 12V Wires For The Led Strips That I Added Above And Below The Acrylic.I Then Hot Glued The Strips On. This Version Is A Little Different Then The One In The Picture, I Have Added Space For A Toggle Switch To Turn Power Supply On/Off. If This Is Not Needed Then You Can Just Remove It :) The Hardware Needed Is: 2 - #6-32 1/2In 8 - M3X13Mm 4 - M3X20Mm 5 - M3X10Mm 5 - M3X22Mm 12 - M3 Hex Nut Other Material: 12X24In 1/4In Ply Clear Acrylic Black Acrylic 12V Led Strip Or Tape Hot Glue
Statistics
Likes
11
Downloads
0