RepRapPro Mendel Tricolor direct-drive extruder
Description
This Is A Mount For The Flexible-Filament Remix Of The Leapfrog Creatr Extruder By Eliscott02. I Remixed It For Printing Flexible Filaments On A Reprappro Mendel Tricolor With A J-Head Hotend. This Extruder Prints Filaflex (84A) Pretty Well, Which Is Supposedly 1 Shore Softer Than Ninjaflex (85A). I Print Filaflex At 240 Dc At 40Mm/S, 125% Extrusion. I Set Esteps/Mm To 96 In Firmware. I Have Occasional Inconsistencies In Extrusion, I Actually Notice A Decrease In Printability At A Lower Speed, Possibly Due To Heat Creep On The J-Head. I Haven'T Yet Retrofitted A Fan For The J-Head. Otherwise, It'S Been Quite Reliable.
Statistics
Likes
4
Downloads
0