Robo3d Filament spool holder
Description
Here'S A Remix Of Noudje'S Spool Holder. I Adjusted It To Use M5 Screws And Roller Bearings Which Are 14X5X5. Linked Below Are The Bearing I Purchased For This Project. The M5 Screws I Acquired From Ace Hardware, And As Such, Any Major Store Like That Should Carry Some. Http://Www.Amazon.Com/Gp/Product/B008X18Pnc?Psc=1&Redirect=True&Ref_=Oh_Aui_Detailpage_O03_S00 Each Wheel Houses Two Bearings On Either Side, So You'Ll Need 8 Bearings In Total. Noudje'S Base Design For The Spool Holder; I Find It One Of The Best Designs For Adding The Spool Holder On Top. It Gives The Filiment Spool A Nice Smooth Action To Roll On, Rather Than The Rough Action It'D Have On A Typical Spool Holder That Is Composed Of 2 Support Structures And A Bar In Between. There'S Only One Other One I Found That'D Match In Quality Of Design, However, It'S Also A Little More Complex In It'S Setup. Best Yet Is The Offset, Which Has The Filament Coming Down In A Straighter Line, Rather Than Bent In Like Spool Holders That House It Directly Above The Slot. With Filament That Is More Delicate, It'S A Must. It'Ll Lead The Filament Off The Spool In A More Natural Position.
Statistics
Likes
16
Downloads
0