Better washer for Printrbot Alu Extruder v1
Description
I Noticed That The Black Plastic Piece (Nylon?) That Goes Through The Alu Extruder Prevented The Washer From Being Flush Against The Extruder. This Added Some Wobble To The Spring Arm. I Used Some Folded Up Paper To Remedy This Temporarily, But This Piece Works Much Better. I Also Noticed That The Top Portion Of My Stepper Motors Threading Got Stripped, So I Switched To A Longer M3 Screw. I Used A 35Mm One, But A 25Mm Should Work Too (You Probably Wouldn'T Need The Extra Nut In There If You Went With A Shorter One). To Use, Just Put This Piece In Between The Metal Washer And The Black Plastic Piece. In The Picture You Can See The Printed Piece In Clear Pla. Not Sure If This Would Help With Alu Extruder V2 (Maybe Someone Can Test It Out And Leave A Comment)
Statistics
Likes
3
Downloads
0