Car radio head unit rear support, 4mm
Description
This Thing Goes In The Back Of Your Car Radio Head Unit, And Basically Supports It From The Rear. It'S Often Found In Dash Trim Kits For Radios, But Sometimes You Lose It Or It Never Came With The Kit And You'D Call Up The Manufacturer And Ask For One But *You Can'T Be Bothered To Email Them And Hope They Reply And Then Wait A Few Weeks For Them To Ship One To You Because You Need To Install Your Radio* ***Right Now Dammit.*** This Is Why We Have 3D Printers. I Made This With A Hole For An M4 Screw. To Use, Find An M4 Screw 15-20Mm In Length. Screw It In To The Hole Of The Thing. That Will Cut The Threads. Now Unscrew. Cut Off The Head. Now Screw The Crapped-Up End (The Ruined End That You Took The Head Off Of) Into The Hole In The Thing Until You Have 6Mm Or So Left Sticking Out. The Amount Left Sticking Out Should Not Exceed What The Radio Manufacturer Said Was The Max, If They Even Specify It. Mine Said 8Mm. Anyway, Now You Can Screw This Into The Back Of The Head Unit, And You Have Rear Support. And You Didn'T Have To Deal With Some *Crappy Company* With *No Quality Control*.
Statistics
Likes
1
Downloads
0