SYMA X5SC simple foot replacement
Description
This Thing Is A Very Simple Replacement Part For A Syma X5Sc Quadcopter'S Foot. This Design Prints Much Faster (Takes Just A Few Minutes To Print) And Is Lighter Than My Previous One (Http://Www.Thingiverse.Com/Thing:1141251). <Strong>It'S Also Lighter Than An Original Syma Foot.</Strong> You Will Need Two Pieces Of 3Mm Diameter Filament (About 6-7Cm Long) That Will Take Place In The 3Mm Diameter Holes At The Base (Going Thru It About 7Mm - See Photo) And The Two Other 3Mm Diameter Holes At The Tip. If You'Re Using Abs, They Can Be Glued In Place With The Use Of Acetone. I Printed The Parts With Abs But Used Hdpe For The Filament Parts (Unglued). I Think Hdpe Filament Does A Better Job Because It'S Softer And Bends Easily Without Breaking Which Is A Good Point Here. Just Mount It Like The Original Foot And Fix It With The Help Of The Original Small Screw. This Foot Design Is <Ul> <Li>Easy And Fast To Print</Li> <Li>Light</Li> <Li>Strong</Li> <Li>Nearly Unbreakable</Li> <Li>Modular (Length)</Li> </Ul>
Statistics
Likes
6
Downloads
0