Minotaur 54mm
Description
Back After Short Rl Hiatus, I Finished This Late Last Month 52 Mm Minotaur Stands About 70Mm. Lightly Inspired By Kobl Minotaur. I Highly Suggest Hips Printing For My Figures On Fff Machines However This Fella Should Be Large Enough To Manage Without. I Also Suggest Dialing Down The Speed For Hips Printing, See Below This Model Is Designed For Hips Printing. Https://Timeportalgames.Com/Wp/ 28Mm Model Versions Available Through Timeportalgames.Com Or Buy At Https://Www.Shapeways.Com/Shops/Timeportalgames. Assembly Required:Will Likely Require Xacto Blade, Or Sanding, And Superglue To Assemble Weapons/Shields To Figure. We Advise The Following Settings For Slicing Layer Height: Between .2Mm Auto_Support: Between 1- 1.5Mm Or 40-50% Hips Fill Fill Density: 15% Or Greater 3 Shells Print Speed 30 Outlines 75 Fill Other Notes Glass Plate With Hips Slurry Allows For Plate To Heat Only To 100C Without Issue. Many Free Designs Available At Https://Timeportalgames.Com/
Statistics
Likes
75
Downloads
0