Front Y Carriage Melamine reinforcement for Sunhokey Prusa i3 2015
Description
The Front Acrylic Plate On The Y Carriage Was Pretty Well Bent Due To The Belt Tension, I Had To Do Something About That, And I Thought I Could Just Design A Reinforcement Part. I Printed It A Little More Thin (60% Height) At 50% Fill And It Works Like A Charm (Pla, 0.2Mm Layer), Rotate It At 45° In Order To Fit On The Print Bed (If You Have A 20X20Cm Bed). Just Ease Out The Holes (A Few Turns With A Smaller Drill Did Tha Trick) And You'Re Good To Go. I Can See An Improvement In Y Axis Quality (Used To Be Great And Degraded Over Time To To The Belt Losing Tension Little By Little), And It'Ll Avoid The Acrylic Plate To Break.
Statistics
Likes
23
Downloads
0