Robo 3D Filament Holder Slot Aligned
Description
This Filament Holder Aligned The Filament To The Slot So That Least String Bending Would Incur Before The Filament Feed Into The Extruder. It Would Fit Filament Holders Of Width Of Less Than 74Mm. The Filament Could Be Held In Two Ways. With One Pin Going Through The Spool Hole And Held By Part 3 Or With Two Pins And Four Bearing Serves As Bottom Rolling Wheels And Hold The Spool. To Install The Hinge Pin And Ball Bearing Wheel: Put Two Ball Bearing Into One Hinge Pin. Push The Hinge Pin And Ball Bearing Into One Hole. The Hinge Pins Cap Facing Your Self. Push The Other Ball Bearing Into Another Hole. The Hinge Pin Should Now Rotate Freely And Sits Nicely Inside The Ball Bearing. Repeat For The Other Hinge Pin And Two Ball Bearings. The Hinge Pins And Ball Bearing Wheels Can Be Purchased Here: Http://Www.Lowes.Com/Pd_308895-1277-S841-563___?Productid=4767377&Pl=1&Ntt=0308895 Http://Www.Amazon.Com/Gp/Product/B010Gi2Zcg?Psc=1&Redirect=True&Ref_=Oh_Aui_Detailpage_O07_S00 Use Super Glue To Glue Part 1 And 3. Use M6 Screw To Screw Down Part 1 And 2 Thru The Slot And Secure The Whole Filament Holder. You Can Use The Part 1 And Part 2 Only For 1Kg Spool, But For Thin Spool, Such As The 300G Spool Came Included With Robo3D, The Spool Could Fall Down. You Need To Print Part 2 To Block Both Sides. This Spool Holder Is Smooth Compared To Many Other Holders I Printed Before And I Like It. That'S Why I Am Sharing With Other Robo3D Users.
Statistics
Likes
32
Downloads
0