Dingbot, the Mechanical Bell Choir
Description
A Midi-Controlled Bell Choir I Designed. For More Information And Videos, See Http://Www.Shamlian.Net/Projects/Bellchoir/ . Nearly All Hardware Is #4; M3 Probably Work, Too. Stops Are Keystone 720, But Any 1/4" Rubber Bumper Should Work. The Hinge On The Clapper Is Keystone 351. The Only Hardware That Isn'T #4 Is The Set Screw For The Motor, Which Is A 1/4-20 X 1/4", And The Two Screws Each Holding The Motors In, Which Are M2.6 X 8.
Statistics
Likes
21
Downloads
0