Adjustable GPU Support Bracket
Description
I Designed This Thing Because I Have A Rather Large Graphics Card That Sags And I'M Always Worried I'M Going To Damage Something When I Transport My Computer. This Gpu Bracket Is Completely Adjustable To Work With Any Gpu That Has A Heatsink Cover, And Should Work With Any Case That Has Recessed Expansion Slots. It Attaches Via The Existing Expansion Slots In Your Case. Extra Materials Include 5 Small Screws, And 2 Small Washers Or A Chain Link, Which Is What I Used. I Printed This Part With Abs Filament On A Xyz Da Vinci 1.0 Printer. The Back_Plate Should Be Printed With A Relatively High Infill Density As There Will Be A Lot Of Stress On That Part. I Printed All The Other Parts At 10% Infill Density. Note: -When I Was First Putting The Screws In And Creating The Threads, The Friction Caused The Wall In One Of The Holes To Break. I Recommend Putting A Bit Of Acetone In The Holes To Soften Up The Plastic When First Making The Threads. -Take The Care Not To Over Tighten The Adjustable Slider, Because On My First Try I Tightened It Too Much, Causing The Back Plate To Snap In Two.
Statistics
Likes
242
Downloads
0