FC350BJ_110v Motor Controller enclosure
Description
I Needed A New Enclosure For My Sieg X2'S Motor Controller Since I Put A 4In C-Channel On The Back Of The Column. It Prints In A Number Of Pieces To Fit On A 9X6 Printer Easier. Requires M3X.5 X 8Mm Screws Here And There. Mostly Shcs But A Few Of Them Are Flat Heads. If You Can'T Figure Out Which Ones Just Message Me. There'S Also Provisions To Include A C6 Spindle Controller Inside So You Can Have Mach3 Control Your Spindle For A Bit Safer Operation.
Statistics
Likes
6
Downloads
0