Specific Nexus 6 with Qi Charger Stand
Description
This Is A Very Specific Phone Charging Stand I Made For My 2014 Motorola Nexus 6, The Guts Of A Cheap Chinese Qi Charger And A Car Window Cell Phone Mount Arm. I Took The Guts Out Of A Cheap Chinese Qi Charger, Put Some Electrical Tape On The Back Of The Electronics Board And Then Folded It Over Super-Glued It To The Back Of The Qi Charging Plate. I Then Designed This Phone Holder To Fit That Qi Charger Guts And My Nexus 6 Along With Holes To Mount It Onto A Standard Car Window Phone Holder Arm. The Qi Charger Guts Slide In From The Top With The Mini-Usb Connected At The Bottom. You Then Plug In The Power Cord From Underneath. Its A Little Tight Getting My Chubby Fingers In There, But Doable. All This Because I Have A Very Small Desk And Nowhere To Lay The Charger Down. So Now I Have It Mounted To The Side Of My Desk, Out Of The Way, But Still Easily Accessible. I Made It Extra Thick And Tough Because It'S Hanging A $600 Phone Off The Side Of My Desk! I Am Not Responsible For Any Damage Occurring To Your Phone, Floor, Or Dog Lying Under It (Or Anything Else) Should You Build This And It Fails For Whatever Reason. Nor Am I Responsible For Anything Else That Goes Bad In Your Life... Maybe You Have A Similar Situation, Or This Will Inspire You To Make Something Like It...
Statistics
Likes
4
Downloads
0