Micromake blower-fan-duct and effector
Description
Edit Apr-3-16: I Added A Revision Of The Duct Because I Felt That The Flow Of Mk1 Was Not Good Enough And Also Because I Sometimes Print Abs With No Fan But That Made My Duct Melt :) The New Model Has Better Flow And Should Be Printed With Support. I Had Originally Designed A Duct For A 40Mm Fan But Discovered That My Pla Prints Were Looking Nice Only On One Side Because The Other Wasn'T Being Cooled Effectively. I Had A Blower Fan In The Draw That I Purchased From Aurarum.Com, Which Had A 12.5Mm X 17Mm Opening And Fit Nicely Above My Effector So I Set About Making A Mod. I Push-Fit My Blower Fan Onto The New Effector Duct And It Sits Nice And Tight With No Leaks Or Wobbles. I Then Printed The Duct Out Of Abs Because It'S Next To The Hot End. It'S A Good Fit And Blows A Lot Of Air Down On The Bed Below The Tip From All Sides Now My Parts Look Good From All Angles!
Statistics
Likes
3
Downloads
0