Beginners Quad
Description
I Found This Design Scurrying Around Down At The Bottom Of My Hard Drive. If I Remember Right This Was A Design That I Did Up Right Quick To Satisfy The Pre-Rec So I Could Take The Classes To Get My Drafting Certification. This Quad Was Designed To Press-Fit Mount 380 Size Standard Car Motors And Hold A 1300Mah 3 Cell Lipoly Pack. Although The Motor Pods Do Fit On The Ends Of The Arms Quite Snugly A Dab Of Glue Wouldn'T Hurt Ta Just Keep Em On There Good An Tight. You'Ll Also Need 8 Small Bolts (Sorry, Don'T Remember The Size Of These) And You'Ll Also Need A Couple Of Bolts With Wingnuts Or Thumbscrews For The Battery Strap. Assembly Requires That The Arms Go In-Between The Chassis Plates. *Note* The Motor Pods Have A Hole At The Bottom For Motor Wires To Lead Through But This May Be Too Small For Some Wire Packs But I'Ll Fix This As Soon As I Get The Chance After Break.
Statistics
Likes
1
Downloads
0