Flashforge & Clones Inland Filament Spacer
Description
This Is A Remix Of Trevorjb'S Flashforge Creator Filament Spool Spacer (Thing: 504298). I Made A Couple Of Those And Realized They Wouldn'T Fit The Filament Spool I Was Trying To Put Them On, They Were About 4 Or 5 Mm Too Big. I Was Trying To Use It On Inland Filament Which Can Be Purchased, Among Other Places, At Microcenter In The Us Pretty Cheaply. This Is Basically The Same Design But With A Smaller Outer Diameter To Accommodate The Filament. It Should Work With Most Of The Flashforge Models And Clones With Dual Spool Holders On The Back. You Need To Print Two For Each Spool Holder You Want To Use It On.
Statistics
Likes
14
Downloads
0