terraPin Prime 6X6 Pinhole Camera -120 Film
Description
A New Terrapin Pinhole Camera: Fewer Parts, Fewer Vitamins, Easier To Build. If You Have Been Hesitant To Print, Assemble, And Shoot Any Of The Schlaboratory 3Dprinted Pinhole Cameras, This Is The Camera For You. Only 4 Parts To Print For The Body And Shutter Assembly, With A Variety Of Winder Options. Fewer Bolts (Can Be M3 Or 4-40), More Gaffer'S Tape. Frame **6X6** "Focal Length" **26.75 Mm** Angle Of View **90 Degrees** Nominal Horizontal/Vertical Designed For **0.23Mm** Diameter Pinhole F/116 - F168; **Nominal F/135** All Sample Photographs Are 6X6 Format; View At Full Screen. I Will Post All Photographs I Make With This Pinhole Camera [On Flickr, Here](Https://Www.Flickr.Com/Photos/Theschlem/Albums/72157660939060664) See [Terrapin High-Strength Winder (1/4" Shaft)](Https://Www.Thingiverse.Com/Thing:2394417) For Additional Winder/Knob Options! ___ **Attention** This Work Is Licensed Under The [Creative Commons - Attribution - Non-Commercial License](Http://Creativecommons.Org/Licenses/By-Nc/3.0/). This License Applies Only To The Files And Documents Available For Download From The **Thing Files** Section Of This Thing. **All Other Related Content (Photographs, Videos, And Verbiage Such As Contained In "Description" Or "Instructions" ) Are Excluded From This License, With All Rights Reserved, Unless Specifically Available For Download** This Notice Constitutes A Clarification, Not A Change, To Licensing For This Design.
Statistics
Likes
240
Downloads
0