Wind guide for HICTOP Desktop 3D Printer
Description
Update: Version 1.3 Honeycomb Fan Grill. Printed At .125Mm Resolution (If You Go Any Higher Than This The Honeycomb May Not Turn Out So Great.) 100% Infill (Just My Own Preference) Printed With Supports Through Cura Software. Support Type: I Printed This With Touching Build Plate Only Setting. (Note: This Is Probably The Most Important Setting For A Fan Guide Designed Like This. If You Print This With Supports Everywhere, You Will Have Difficulty Fishing The Supports From Inside The Enclosure. I Had No Issues With Sagging Or Warping On The Outlet Hole. Version 1.2 Here Is A Moderately Modified Wind Guide For The Hictop Desktop 3D Printer. I Widened The Inlet-Outlet Of The Shroud. The Base For Mounting With Screw Holes Has Not Been Modified. I Wanted More Coverage Area For Cooling. I Have Found That I Get Less Warping On Corners And The Overall Print Because Of A More Even Cooling With This Shroud. Printed At 0.125 Resolution/Layer Height 100% Infill Supports
Statistics
Likes
36
Downloads
0