Geeetech i3 X - X carriage set with circular fan duct
Description
An Alternative X-Carriage For Geeetech Prusa I3 X. Made For A Smooth Rod Separation Of 45Mm (Not The Default 70Mm). It Was Designed To Have Some Minor Advantages As Compared To The Stock Geeetech Carriage Set: - Easier Removal Of The Extruder From The Carriage: Unscrew Two M4 Screws From The Bottom And Pull The Extruder Forward Through The Gap (Backplate.Stl) - Cable Gaps For Hot-End Cables And Motor Cables At The Bottom Of The Back Plate -> No Loss Of Build Volume In Any Direction - Back-Mounted (M3 Screw And Nut) Cable Holders And Pass-Through-Holes Allowing To Fixate Cables At The Back Side (Back-Cable-Holder.Stl) - Alternatively A Cable Tie Can Be Used By Means Of A Provided Additional Hole - Fan Shroud For The Existing 40Mm Fan To Cool The Hot-End A Bit (Fan-Duct-1.Stl) - 3 Sets Of Frontal Mounting Holes Made For M3 Nuts (Separation: 24Mm, 40Mm And 78Mm) - Easy And Convenient Mounting - Circular Fan Duct For Perfectly Uniform Cooling Flow (Fan_Duct.Stl) - The Duct Is Designed To Have A Distance Of 3Mm From The Print Bed To Not To Rip Off The 4 Binder Clips. However, The Minimal Distance From The Heater Block Is 1Mm. Two Led Mounts Are Provided. - Less Weight Than Solid Acrylic - The Heads Of The Screws And Washers Are Hidden Within The Backplate - See Also The Corresponding Backplate: Https://Www.Thingiverse.Com/Thing:1485794 Limitations: - The Provided Belt Fixation (Belt_Fixation.Stl) Can Only Be Used With Low Profile Sc8Uu Bushings/Bearings (I.E. Http://Www.Thingiverse.Com/Thing:1196801) - You'Ll Potentially Need Shorter M4 And M3 Screws. This Was Designed For 10Mm M3 Screws And 10Mm And 16Mm M4 Screws. - The Back Cable Holder May Limit Your Maximum/Minimum X Distance (In My Case Reduced By -3Mm) - There Is Not Much Room For The Circular Fan Duct. Take Care Not To Melt It By The Heater Block. _Update 23.01.2016: Fixed Belt Fixation: Belt Was Not Fixed Properly _Update 28.02.2016: Added Version For Gt2 Timing Belt With 1.38Mm Height (Attention: Some Gt2 Belts Have A Height Of 1.7Mm Or 1.54Mm) _Update 18.10.2016: Widened Support For Backplate (Backplate V1.1.Stl) For Larger Nozzle Diameters.
Statistics
Likes
203
Downloads
0