lulzbot retract settings & marlin fw
Description
I Was Having A Hard Time Getting Retract Settings Right On My 3D Printer So I Searched The Net For Configuration Files. I Came Across Lulzbot That Has Cura Settings For Almost All Filaments Commercially Available. I Also Recently Changed My Firmware To The One Used On Lulzbot Printers Just Slightly Modified. <Font Color=Red>If You Want To Use My Firmware You'Ll Need To Mod It For Your Setup.</Font> I Have It Set For Dual Extruders,Temp Sensor 11 Both Hotends, Auto-Leveling Enabled And Mk8 Direct Drive Gear. <Font Color=Red>The Cube Is There Only Because Its Needed To Post This</Font>I Will Soon Add The New Firmware Settings I'M Using With Wades Extruder, Which I Find Easier To Use Strength And Heat Wise.
Statistics
Likes
13
Downloads
0