Resting Robot Cellphone Stand

Description

This Is My First Model On Thingiverse, A Cute Little Robot That Looks A Bit Tired But Is Always Happy To Hold Your Cellphone For You. Don'T Have A 3D Printer? Just Want One Printed For You? Buy On At [My Shop](Https://Nirrobotics.Com/Product/Resting-Robot-Cellphone-Stand/) There Are 3 Versions Of This Robot: V1 - All In One Piece --- This Is The First Version, It Prints In One Piece And Because Of This It'S The Most Solid And Best-Aligned Version Of The Model. However, It Requires Support Between The Body And The Head And This Support Is Kind Of A Pain To Remove In Cura You Need To Set Support Type To "Everywhere" I Printed It In Pla, 0.2Mm Layer Height, 10% Infill, 0.8 Shell Width And A Raft - But Those Are Probably Not Important. V2 - No/Less Support --- This Version Uses 2 Different Stl Files, One For The Body And One For The Head And Eliminated The Annoying Support From V1 The Body Stl Does Not Need Support At All. You Need To Rotate The Head Stl Before Printing (Make Sure The Head Is Flat On The Bed, In Cura Use The "Lay Flat" Option), You Can Print It In One Of Two Orientations: 1. Neck Up - That Should Print With No Support 2. Face Up - That Will Need Just A Little Bit Of Support But The Face Will Look Better I Print Both On The Same Bed, Head Face Up, With Support (Cura Is Smart Enough To Not Generate Supports For The Body). The Head-Body Connector Should Fits, You May Need To Remove The Support Material From The Neck With A Knife. The Connector Is Designed For A 0.4Mm Nozzle. I Printed It In Pla, 0.2Mm Layer Height, 5% Infill, 1.2 Shell Width And A Raft - But Those Are Probably Not Important. V3 - With Cable Guide --- The Third Version Adds A Little Tunnel To Let You Pass The Phone'S Usb Cable Inside The Body. It'S A Little Bulkier (Thicker Legs And Body) To Allow Room For The Cable, Also, With Phones With Large Rounded Corners It'S Less Stable Because The Force Of The Usb Cable Pushes The Phone. The Cable Comes Out Of The Robot'S Left Side (Your Left When Looking At The Robot From The Front, Right From The Robot'S Point Of View), It Does Not Fit Phones Where The Usb Connector In On The Bottom, If Your Phone'S Connector Is On The Right You Can Mirror The Stl. This Version Uses The Same Head As V2, Please Read The Head Printing Instructions Above In The V2 Section. The Body Does Not Need Any Support. I Printed It In Pla, 0.2Mm Layer Height, 5% Infill, 1.2 Shell Width And A Raft - But Those Are Probably Not Important. The Model Was Designed In Sketchup Make And The Stl Cleaned Up In The Online Netfabb

Statistics

Category

Tags