Flashforge Dreamer - Wanscam IP Camera Bracket and Spacer
Description
*Updated 17Th April 2016* This Is A Bracket To Hang A Wanscam Hw0024 Ip Camera (Or Similar) From The Front Of Your Flashforge Dreamer (And Presumably, The Dremel Idea Builder). It May Work With Similar Ip Cameras That I Haven'T Been Able To Test. Dreamer Lid Can Still Be Mostly Closed When This Is Fitted And The Slight Gap Doesn'T Seem To Have Any Noticeable Effect On Abs Printing Performance. To Open The Dreamer'S Front Door While This Is Fitted, Either Slide The While Bracket To The Side Or Simply Loosen The Camera'S Mounting Screw And Slide The Camera Out. When Printing The Bracket, Supports Will Be Required For The Overhanging Clips. Bracket Should Be Printed In A Heat Resistant Material Such As Abs. To Check If Your Ip Camera Will Fit: Gap From Center Mounting Screw Hole To Furthest Edge: Approx 61Mm Gap From Center Of Mounting Screw Hole To Closest Edge (As The Wanscam Hw0024 Is Rounded At The Front, This Wasn'T An Issue): Approx 58.5Mm
Statistics
Likes
13
Downloads
0