XT60 mount
Description
This Is A One-Piece Xt60 Mount. It Is A Modification Of The Model Http://Www.Thingiverse.Com/Thing:702525. The Source Model Is Two Pieces, And Requires Nuts And Bolts. My Model Is One Piece And Have Some Obvious Advantages Over The Original. Well, There Are Also Some Disadvantages Also. As With The Original, My Model Uses The Square Xt60 Labels To Hold The Xt60 Female Connector In Place. You Can Use That Model To Inject Onto Any Other Component To Hold The Female Connector Sticked On That Place. My Model Does Not Require Any Nuts And Bolts And It Is Just A Single Piece, Which Makes It Easier To Place On Any Other Model. Well, For The Disadvantages, It Is A Bit Hard To Push The Connector To The Place, And Once You Succeed, It Is Almost Impossible To Pull The Female Connector From The Place, Without Damaging The Printed Part. In My Test Environment, I Printed The Piece With Full Infill. Indeed, My Print Settings Forced Me To Have A 100% Infill Because Of The Small Area Of The Holder. However, If Anyone Wants To Use The Piece In Any Other Model, It Should Be Sufficient Just To Have Thicker Walls, Instead Of Full Infill. 1Mm Width Walls (Perimeters) Should Be Enough For A Strong Connection Between The Holder And The Connector.
Statistics
Likes
16
Downloads
0