3D Pen Holder
Description
I Purchased A 3D Pen To Use As A "Glue Gun" To Fix Tabs, Ears And Small Imperfections On Long Prints From My 3D Printer. Since I Purchased The Cheapest One I Could Find On Amazon, It Did Not Include A Pen Holder Or Base. So, I Whipped Up Something In 123D Design And Figured If I Needed It, Someone Else Might Also. So Here It Is... The Holder Is Designed To Make 8 Small Points Of Contact, While Allowing Adequate Airflow Around The Nozzle. It Will Keep The Heat Transfer From The Pen To The Holder To A Minimum. Also The Top Fingers Allow A Little Flex So If You Lightly Push The Pen In, It Can Be Removed Without Lifting The Holder. If You Push The Pen In A Little Harder, It Will Flex And Grab The Pen, Giving It More Holding Power. Lastly, My 3D Pen Tends To Ooze A Lot Of Material When Hot, So I Would Highly Recommend Putting A Piece Of Paper Below The Base.
Statistics
Likes
117
Downloads
0