120 Takeup Spool for 35mm Film: Remix without supports

120 Takeup Spool for 35mm Film: Remix without supports

Description

The Original Design (Http://Www.Thingiverse.Com/Thing:522005) Cannot Be Printed Without Supports And I Don'T Like Supports. A Friend Of Mine Needed This Thing (I Am Not A Camera Expert) So I Splitted In 2 Parts In Order To Print Top And Bottom Separately. The Tenons Are Actually A Bit Smal But It Should Be Ok As Constraints Are In Compression. I Used Blender To Design The Joint. Edit 2016-08-14: As An Answer To This Make (Http://Www.Thingiverse.Com/Make:195089) I Add The Stl For A Sock To Put Around The Counter Barrel To Make It Turn With The Film. This Is Not Tested.

Statistics

Likes

27

Downloads

0

Category

Camera