Blackout Mini H XT60 Mount
Description
Male Xt60 Connector Mount For Blackout Mini H Quadcopter. Slides Onto Two Rear 35Mm Spacers To Accept Female Xt60 From Lipo. Hex Spacer Sockets Are 6.1Mm To Allow For Print Swell. Pocket For Xt60 Will Be A Tight Fit As Designed - You Will Likely Need To Sand The Sides Of The Connector Housing To Get It To Fit Snugly. Some Manufacturers' Connectors Fit Tighter Than Others. A Bit Of Ca Can Be Used To Secure It. This Design Puts The Solder Lugs For The Connector Directly Above The Frame Pdb Lipo Pads.
Statistics
Likes
10
Downloads
0