Cable Chain Riser Wanhao Di3
Description
I Noticed The Cable Chain From The Extruder To The Z-Axis Arm Slopes Down Toward The Z-Axis End, This Was Causing One Of The Links To Pull Apart Slightly. **Update You Are Better Off Using The Remix Of This As It Improves The Design :-)** Http://Www.Thingiverse.Com/Thing:1421438 So I Created This Small Riser Plate, Which Is Nice And Simple And Does The Job Perfectly. It'S 22Mm X 20Mm X 4Mm The 4 Holes Are 3Mm, I Didn'T Have The Correct Length Screws So Used Nuts As Spacers Where Necessary (As The Photos Show). This Was Printed At 200 Microns And 50% Infill, Taking Less Than 15 Minutes To Print And Fit.
Statistics
Likes
22
Downloads
0