Diatone ET 160 cable & antenna holder
Description
I Needed Something To Hold The Battery Wires Out Of The Way From The Props, And A Holder For The Antenna Wires. So Designed This. It Is Designed To Go On The Top Plate, Using The 2 Original Back Screws To Hold It In Place. I Have Made It So You Can Run The Xt60 Connector Through It. I Also Drilled Out The Back Hole In My Top Plate To Take An Antenna Sma Connector. The Antenna Holder Is Designed For 3.2Mm Antenna Tubes, And I Also Made A Channel From The Underside To The Antenna Tubes Which Will Enable You To Run The Antenna Wires Through The Back Slots In The Top Plate Right Into The Antenna Tubes.
Statistics
Likes
33
Downloads
0