Flat Filament Spool Holder - No spring- The Claw remake

Description

<Strong>New Version Available:</Strong> Please Go Check The New Model <A Href="Http://Www.Thingiverse.Com/Thing:1775818" Target="_Blank">Ultra Flat Filamentholder</A> Which Is Updated To Be 8Mm Lower, Be More Accurate And Print Faster :) ---- <H3>Features Of The Flat Filament Spool Holder</H3> <Ul><Li>6. Juni. Finally Finished Making It. Enjoy :)</Li> <Li>Quickrelease With Simple Fingernut</Li> <Li>Very Smooth Spoolmotion With Wellplaced Bearings Supporting The Spool On 4 Points.</Li> <Li>No Special Tools, Screws Or Springs Needed</Li> </Ul> <H3>Parts Description</H3> **2X-Quickrelease-No_Springs** This Part Consist Of 2 Parts But Is Printed In One Go. There Is Room For Fingernut On The Rear End, Which Presses Down On The Break-Away Lower Part Of This Piece. The Lower Part Is Then Pulled Upwards And Together They Squeeze Tight On .. **4X_Pulley-Flanged_Bearing.Stl** This Is The Pulleys Where You Put *2X Flanged Bearings* Into Each. **2X_Lower_Mount_Points** Added Internal Spacer For The *F608Zz Bearings*. It'S Slightly Higher Than The Bearing To Provide Smooth Runnings. **Spacers** I Included A Few Different Spacers To Make Sure You Had Something Fitting Your Printer. <H3>Bill Of Material</H3> <Ul><Li>4X 20Mm M3 Sccrews.</Li> <Li>2X 35Mm M3 Screws.</Li> <Li>10X M3 Nuts</Li> <Li>8X F608Zz Bearings</Li></Ul> <H3>Bom - Specifed</H3> <Ul><Li>Quickrelease Each: 1X 20Mm M3 Screw. 2X M3 Nuts. 2X F608Zz Bearings</Li> <Li>Fingernut Each: 1X 20Mm M3 Screw. 2X M3 Nuts.</Li> <Li>Lower Mount Points Each: 35Mm M3 Screws. 1X M3 Nut. 2X F608Zz Bearings</Li> <Li>Mounting Bracket (Holder): 3X 12Mm Scrwes. 3X M3 Nuts.</Li></Ul> Link To Show The <A Href="Http://Www.Robotdigg.Com/Product/40/Timing+Belt+Idler+F608Zz+Flanged+Ball+Bearing">F608Zz Bearings From Robotdigg</A>

Statistics

Category

Tags