Spider Sentry Turret laser cannon
Description
I Rescaled The Las-Cannon From A Different Model On Here (One Of The Tanks) And Made A Quick And Dirty Sentry Turret Base For It. Edit: Printing It Now, Ended Up Scaling The Whole Thing By .9 In Cura So It Will Fit A 60Mm Gaming Base. Edit2: Strengthened The Feet A Little Bit, Rescaled The Lascannons And Shifted Their Power / Coolant Hoses Up So That The Larger Unit Will Fit On The Base. Edit3: Ok, I Decided That Since This Thing Needed Twin Linked Lascannons, I Needed To Be Able To Aim Them. The Las-Cannons Have A 3Mm Hole In Them, And The Turret Top Has A Hole Through It As Well Now. There Is An Additional Modification To This Now Since I'Ve Printed The First One. I Added An 8Mm Stud To The Turret Base And A Matching Hole To The Bottom Of The Turret Top. This Is So That I Can Make A Few Bases, And Be Able To Swap Out Turret Tops For Either Bolters Or Las-Cannons. My Thought On The 3Mm Hole Through The Turret Top Is To Use A Piece Of Filament As A Pivot Pin And Glue It Into The Lascannons Through The Hole In The Turret Top. I'Ll Use A Nylon Washer Between The Las-Cannons And The Turret Top And Apply Quite A Bit Of Pressure So That It Is A Friction Fit. Hopefully This Will Allow Me To Adjust The Guns A Bit Without Having Them Floppy. Edit - Final 3/16/2016: I Repaired The Mesh To Fix Where It Filled The Holes On The Turret Top. Print It Lying On Its Back. I Also Repaired The Bit Of Mesh Around The One Leg Of The Base Where It Ended Up Leaving A Tiny Gap When Slicing And Printing. I Still Did Not Scale These Down, So If You Want Them To Fit A 60Mm Base, Scale When Slicing To .9
Statistics
Likes
151
Downloads
0