Slim wallet key holder
Description
I Created This Wallet Card Key Holder To Allow Me To Place My Keys Directly Into My Slim Wallet Without Them Falling Out. The Wallet Card Is 3 Mm Thick Overall And The Shallower Part Is 1 Mm Thick. The Hollow Part Allows For The Screw Head To Sit Flush In The Wallet. I Put My 2 Keys Together With A Chicago Screw That Is M4 (4 Mm Diameter Post) With A 4 Mm Length. I Prevent The Screw From Coming Unscrewed By Securing It With Threadlocker Blue 242. The Card Is Id-1 Size, Which Is A Fairly Standard Size And Should Fit Most Wallets. The Wallet In The Photo Is The Slim 3 From Supr (Https://Www.Suprgood.Com/Collections/Slim-3-Wallets). I Previously Used The Slim 1 Which Works Well Too. This Does Add Slight Bulk To My Slim Wallet, But Previously My Keys Would Occasionally Just Slip Out Of My Wallet If I Wasn'T Careful, Whereas Now They Are Very Secure. The Keys Are Still Easy To Remove. I'M Not A 3D Printing Expert, So Unfortunately I Can'T Give A Lot Of Guidance On The Printer Specifics. Printing It With Pla And 20% Infill Seemed To Work Fine Though!
Statistics
Likes
0
Downloads
0