Hasbro Lightsaber Waist/Belt Holster
Description
This Is A 3-Part Holster For The Hasbro Extendable Lightsabers. I'Ve Tested It With My Kids' Luke And Darth Vader Versions, So Hopefully It Fits Others As Well. No Supports Are Necessary For Any Of The Parts Except The Belt-Clip. I Think It'S Best To Print It In A Horizontal Orientation So That It Can Better Withstand The Flexing Of Repeated Sliding In And Out Of The Waistband. The Bottom Section Slides Into The Middle Section And Should Hold In Place Just With Friction And Gravity, But If It Gets Loose There Is No Reason You Couldn'T Apply A Little Glue To Lock It In Place. Lastly, I Printed These With Petg At 0.32 Layer Height With A 0.8Mm Nozzle. But That Was Just My Preference, They Will Of Course Prints At Higher Resolutions Just Fine.
Statistics
Likes
1
Downloads
0