Double Mac Arch/Stand
Description
The Original ( Https://Www.Thingiverse.Com/Thing:2135190 ) Was Perfect For My Mac, A Little Loose But That Was Fine. After I Received My Ipad, I Needed A Place For It. So I Thought Why Not A Double Arch. The Original Model Was Just Doubled So That All Proportions Are Included As In The Original. I Use It With A Macbook Pro 2016, It Sits A Little Loose But It'S Easy To Take Out. The Top Opening Is 18Mm Wide. At The Widest Point The Arch Is 39Mm And In Length 168Mm. For The Best Quality I Aligned It As It Would Stand And Turned On The Supports Everywhere (Prusaslicer 2.3.0). With A Slice Height Of 0.20Mm, My Ender 3 V2 Took About 4 Hours. If I Put It On Its Side And Also Print With Supports Then I Come To Just Under 2.5 Hrs, But The Quality Suffers In My Opinion. Infill Always At 25% But That'S Up To You, You Just Shouldn'T Go Below 15%. Have Fun Printing!
Statistics
Likes
1
Downloads
0