Bicycle Bar End
Description
This Is A Bar End For A Bicycle. Works Great To Keep The Grips From Sliding Off Especially With Shimano Grip Shifters. It Uses An Expanding Wedge Design For A Very Secure Fit, While Being Easy To Install And Remove. Uses An M3 Socket Cap Screw And A Threaded Insert (M3 And Any Length From 5Mm To 10Mm, I Used 10Mm). Measure The Inside Diameter Of The Bar. I Included Two Most Common Sizes: 18Mm And 19Mm. Note, The Wedge Can Expand Quite A Bit And Accommodate A Slightly Larger Handlebar Diameter. But The Closer The Fit The Better It Feels. Printing: I Print These In Abs With No Support, No Raft, And No Brim. There Is A Built In Support In The Top Piece (Yellow Cylinder In The Pictures) Which Is Easily Removed. You Might Want To Add A Wall Or Just Print Something Else Alongside To Slow The Print Down A Little As The Parts Are Conical And The Layers Get Pretty Small As Print Finishes Up. Use A Soldering Iron To Install An M3 Threaded Insert In The Bottom Of The Internal Piece. I Use A 5Mm Drill Bit To Cleanup The Bore And Punch Out The Built In Support (Yellow Section In The Pictures) In The Top Piece.
Statistics
Likes
0
Downloads
0