CR10 v2/v3 Filament Side Guide
Description
I Decided To Mount My Spool On The Left Side Of My Cr10 V3, Right On Top Of The Control Box, But It Gives Me A Problem. At Some Height Level The Filament Will Rub Onto The Gantry Bar Or The Angle Is Too Tight Then It Creates Drag That Prevent The Filament To Go Smoothly Into The Extruder. So I Made This And Solve My Problem There Are 2 Parts, The Guide Itself And The Ring Lock Ring Lock Is Optional But Recommended, And The Ring Lock Is Designed A Little Bit Hard To Insert But It Will Lock Nicely Once It'S In Place You Have To Jam Or Disable The Filament Sensor Because This Design Won'T Accommodate That
Statistics
Likes
0
Downloads
0