Router accessory insert for Bosch GKF 12V, based on FrogBox V2
Description
I Designed This Insert For The Frogbox V2 (Https://Www.Thingiverse.Com/Thing:4094861) To Store A Few Common 6.35Mm (1/4") Router Bits, Plus The 17Mm Spanner For The Bosch Gkf12V Collet,And An Allen Key For Changing Guide Bearings. There Should Be Enough Space To Fit A Reasonable Range Of Bits. One Of My Guided Flush Trim Bits Was Too Tall To Fit In The Standard Frogbox, But It Still Found A Nice Home In This Box With Its Original Protective Tube To Prevent It Chipping The Other Bits. Of Course You Could Stretch The Frogbox Lid Height To Accommodate Taller Bits If You Wanted To. Let Me Know If You Need A Version With 8Mm (Or Other Size) Holes, I Should Be Able To Adjust The Design Easily. You Will Probably Need To Run A 1/4" Drill Bit Down Into The Router Bit Holes To Clean Up The Seams Left By The Printing Process. I Prefer Cleaning The Holes Up For A Good Fit Rather Than Printing Them Oversize To Avoid The Bits Rattling Around, Possibly Colliding With Each Other And Becoming Chipped.
Statistics
Likes
0
Downloads
0