Tronxy X5SA BMG Dual Drive Extruder and Filament Stop Mounting Plate
Description
The Original Design Of A Tronxy X5Sa Printer Has The Extruder And The Filament Stop Detector Mounted On Two Separate Plates At The Outer Rear Right Vertical 2040 Profile.. Unfortunately This Results In Maximum Required Length Of The Ptfe Bowden Tube. Obviously Not The Best Design. The Bowden Tube Can Be Shortened About 20% If The Extruder Is Mounted In The Middle Of An Upper Horizontal Frame Part. The Rear Seems Usually To Be The Best Place For This. To Overcome This, Some Re-Work On The Original Mounting Plates Is Required. I'Ve Already Done This For The Non-Titan Original Stock Extruder: Https://Www.Thingiverse.Com/Thing:4872679 Although That Thing Can Be Used With Bmg Extruder Too, I Remixed It To This Thing, Especially Adapted For Bmg Extruders. This Is Because Of The Position Of The Filament Run Out Sensor. Is Was A Design Goal To Position Filament Run Out Sensor And Extruder In A Straight Vertical Line Regarding Filament Run. Since The Bmg Extruder Is Much Thicker Than The Non-Titan Original Stock Extruder There Need To Be An Adjustment In X Direction Too. I Have Also Designed A Corresponding [Tronxy X5Sa Spool Holder In The Rear 2040-Profile Vertical Plane](Https://Www.Thingiverse.Com/Thing:4868579).
Statistics
Likes
0
Downloads
0