Sawstop Guard Dust Collection Blast Gate
Description
Dust Collection Blast Port For The Blade Guard Dust Collector. I Have A 4" Line Running To The Saw Then It'S Split With Y Between The Guard (Which Has A 2.5" Line Running To It) And A 4" Line (With A Restrictor To Make That 1.5" To Balance The Suction). So I Made This To 1) Reduce From 2.5" To Sawstop 1.5" Port And 2) Allow Me To Turn Off The Guard Dust Collection While Still Running The Bottom 4" (Restricted) Port. I Used Four (4) 3Mm X 16Mm Screws And Threaded Inserts In The 2.5" End. You Can Use 3Mm X 20Mm Screws With Nuts If You Prefer. I Would Have Gone With 3X20 If I'D Had 4 Of Them, But I Had 3X16 And Inserts So That'S What I Went With. Note: The 1.5" Port Was Too Tight So I Adjusted It With A Heat Gun So It'S A Nice Snug Fit. Use At Your Risk!
Statistics
Likes
0
Downloads
0