Switch Blade (USB stick)

Description

This Custom Upgrade For Your Boring Usb Stick Is Simple To Print And Assemble In Less Than 1H30M * Additional Parts Not Printable Include: - Usb Electronics - Crazy Glue - 2 Pen Springs - Fabric (Customizable) *Instructions: - Scale And Print Plastic Components - Clip In Electronic Component (I Used A"Kingston Datatraveler 3G" ) - Glue Inner 2 Pieces Together - Inset Springs At Back - Line Up Outer Pieces But Do Not Glue Them Together - Wrap Fabric In Notch Around Outside Of Usb - With Small Brush Cover The Fabric In A Layer Of Glue (Be Very Careful Not To Glue Any Moving Pieces) *Trouble Shooting: -If The Usb Dose Not Slide Use Nail Polish Remover And Oil To Clear And Bits Of Leftover Glue And Lubricate The Track

Statistics

Category

Tags