3528 LED Strip Holder for 20/20 Frame
Description
I Wanted Some Good Base Level Illumination On My Delta 3D Printer. Led Strips Are So Much Better Than Led Diodes, So I Made A Simple Little Slide In Case For A Small 3528 Led Strip. The Led Strips Are Only 2 Sections Long (6 Leds) With 2 Wires Soldered To The Bottom End Of The Strip (Which Is Hidden Under The Little Cover At The End). The Hole In The Bottom End Is Angled To Make It Easier To Feed The Wires Through. You Can Attach Them To The Frame With Small Cable Ties Or Some Good Quality Double Sided Carpet Tape. If 3 Strips Are Too Bright For You, (E.G. If You Want To Film What You Are Printing) You Can Either Disconnect 1 (Or 2 Or 3) Or You Can Put A Potentiometer On The Power Line To Control The Brightness. There Are No Specific Print Settings For These, Default Printer Setup Should Be Fine. Another Version To Accommodate A 50/50 Led Strip Is Coming Soon..........
Statistics
Likes
8
Downloads
0