Funnel Support for ring stand
Description
I Needed A Better Support For My Funnels - Easier And Faster To 3D Print Than To Order From The Catalog. The First Version Was A Bit Small, Version 2 Has A 40Mm Support Opening. (Version 1 Is The Only One I Have Printed, And Is Shown In The Photos). Print Support Will Be Needed For Version 2, But V1 Can Print Without. Update: Added Funnel Support_03 File With A Cylinder "Holder" Instead Of The Polygon - Again, Untested - But Should Give A Little Better Support. Slightly Adjusted The Position Of The Center Pin For Locking Along Thicker Stand Rods (Or Less Flexible Plastics).
Statistics
Likes
56
Downloads
0