Eclips3D A16 and A17 rod brackets
Description
Original Parts Were Designed To Be Printed Vertically. This Makes The Parts Susceptible To Cracking Along The Layer Lines. I Remade The Parts So That They Can Be Printed Laying Flat With The Layer Lines Parallel To The Rods. This Should Make Them A Bit Stronger And Alleviate Cracking. Added Files With A Little Looser Tolerances. Rod Hole Is Increased To 10.2Mm, M3 Nut Cutouts Are Enlarged To 5.8Mm.
Statistics
Likes
8
Downloads
0