DIY Head Tracker Box
Description
I Made This Box For The Ardiuno Nano Board And The Sensor For The Diy Head Tracker On Rcgroups. The Box Has No Mechanical Fasteners Just A Tight Fit. If It Doesn'T Hold Well Use A Little Hot Glue On The Inside Corners And Then Push It Together. I May Update The Design, When I Get Some Time, And Add Four Small Screws In The Corners. I Updated The Box And Added Screws To The Corners. The Screws Are 3X12Mm Countersunk Self Tapping. There Pretty Common And Should Be At All The Hobby Shops. I Also Mad The Usb Hole A Little Bigger, It Was A Bit To Tight. I Made A Couple More Changes On This Box And Labeled It V4. I Changed To Some Small 2Mm Wood Screws For A Cleaner Look And I Made The Inside Of The Box A Little Deeper To Accommodate The Pins On The Ardiuno Board. You Will Still Need To Remove The 6 Pins On The End.
Statistics
Likes
18
Downloads
0