Quick Release E3D Fan Duct for Dibond Mendel90
Description
A Fan Duct For Cooling Prints Which Can Be Used Instead Of The Standard Fan Duct When Upgrading From The J Head To An E3D Hot End (In My Case A V6) On A Dibond Nophead Mendel90. It Uses The Same 60Mm Fan As Supplied By Nophead. This Is The Second Version Of This Duct And Incorporates A Quick Release Mechanism As Well As More Flexible Height Adjustment (A Common Request I Got On The Original One Here: Http://Www.Thingiverse.Com/Thing:491316 ) I Have Marked It As A Work In Progress Because Even Though It Works Great I Have Had Issues With The Release Lever Snapping Off (Abs Can Be Very Brittle). I Need To Do A Test Print In Bridge (Nylon) To See If This Solves The Problem. You Can Repair The Lever By Using Acetone As A Glue But I Have Found Even With The Lever Snapped Off It Still Works Great As It Stays In Place With Friction (Depending On Your Tolerances You Might Want Add A Bit Of Tape Over The Top To Make It Push In Tighter). Note: This Will Not Fit A Sturdy Mendel90 It Only Fits A Dibond Mendel90. If Anyone Modifies It To Fit Please Let Me Know And I'Ll Include A Link :)
Statistics
Likes
98
Downloads
0