makerbot 5th gen ninja flex guide for extruder
Description
Hey Everyone I Found This Online , I Attached The Stl. For The Makerbot Smart Extruder Upgrade To Allow You To Work With Ninja Flex. It May Take A Few Tries, But You Will Eventually Get The Hang Of It. As Mentioned In My Previous Post, I Used The Recommended Settings From Ninjaflex. Keep In My That By Opening Your Smart Extruder, You Void The Warranty. Lift The Wheel To Facilitate Installing The Piece Around The Groove. It Should Fit Snug Opposite The Circuit Board. The Tail Will Be Above The Magnet To Prevent It From Spinning. This Piece Will Prevent The Ninjaflex From Buckling By Removing Any Gap That Can Be Used By The Filament To Squeeze Through. Have Fun Printing! Http://Animechats.Com/2015/11/15/Makerbot-5Th-Gen-Printing-With-Ninja-Flex/
Statistics
Likes
11
Downloads
0