bottle drying stand 3 leg
Description
I Love The Original Design But I Felt I Was Wasting Too Much Plastic On This. I Designed A 3 Leg Version To Save From Printing 1 Arm On The Base. I Will Be Printing This Soon But I Am Sure It Will Be Fine. I Made Sure The Tolerances Of .6 Is The Same Across The Board. I Cut Out One Of The Holes With Tinkercad Then Filled In Another So It Held 0 Legs. Then Added That Hole Into The Blank Spots. Turned Out Quite Nice. Legs Are At 29 Mm And Inside Is 29.6800 At The Widest Point.
Statistics
Likes
9
Downloads
0