Orignal iPad Wall Mount
Description
I Use The Original Ipad For Shortwave Listening And Wanted To Get It Off The Table Top. The Two Size Brackets Are Due To Mainly Forgetting About The Volume Control Which I Don'T Use In My Application. (Designed The Lower Bracket First) The Larger Bracket Is The Lower One To Support The Weight, ; ) (Sounds Like A Good Cover) The Smaller Bracket Is The Top And Has A Slide For The Mounting Screw. Tighten The Top Mounting Screw Where The Top Bracket Will Move With Force To Hold The Ipad In Place. I Flanged The Mounting Screw Holes To Use #10 Flat Head Screws However, #8 Dome Head Screws Should Work Fine Also. The Rear Mounting Is .125" Thick Allowing The Power/Charger Cord To Be Routed Between The Brackets If Needed. (See Picture) I Have Placed 4) 3/8" Recesses On Each Bracket For Self Adhesive Felt Pads To Hold The Ipad Better. I Printed The Brackets With Pla Using .2 Mm Layer Height And At 10% Fill. Note: You Could Also Just Print Two Of The Upper Brackets For The Mount, They Are Heavy Duty Enough And Save Some Material.
Statistics
Likes
147
Downloads
0