Fan shroud, dual cooling fan mounts, + ring LED mount for E3D v6 hotend.
Description
Integrated Hotend Fan Shroud, Dual Part Cooling Fan Mounts, And Part Light (Ring Led) Mount For E3D V6 Hotend. This Will Fit Under A Standard Kossel Delta End-Effector Mount And Any Other Printer That Can Take The E3D V6 Hotend With Fan Shroud Attached. Print (2) Fan Director Ducts And (1) Each Of The Led Mount And Shroud. Requires A Separate Output (Fet) For Part Cooling. My Led Is Wired To Another Fet Output And Turns On 100% When I Put The Printer In Run Mode. I Have My E3D Fan Turn On With Printer Power So It Is Always Cooling Hotend. Uses (Hardware) (1) Uxcell® 80Mm 24 Smd Led Car Angle Eye Halo Ring Light (2) Generic 30Mm X 30Mm X 10Mm Fans (12V) For Part Cooling (1) E3D 30Mm X 30Mm X 10Mm Fan (Or Generic If No Fan Supplied With E3D V6) (6-12) 3Mm Shcs Bolts X 12Mm Long To Attach Fans To Mounts (2 Per Fan Is Sufficient For Me) (2) 3Mm Flat-Head Bolts X 8Mm (Or Shorter) Long To Attach Cooling Ducts To Led Mount (2) 3Mm Shcs Bolts X 12Mm Long To Attach Cooling Ducts To Hotend Shroud. (1) Small Zip Tie If Necessary To Keep Shroud Tight To Hotend. (I Haven'T Used It Yet, But I Included It In The Design Just In Case)
Statistics
Likes
114
Downloads
0