Yoshi Trophy with custom supports
Description
It Took A Couple Tries To Get The Angled Foot To Print Properly. The Supported Yoshi Is About 90Mm Tall. I Printed It At 0.2Layers, 10% Infill, And A 4 Wall Thickness . I Will Probably Bump The Infill A Bit On The Next Print. This Model Was Converted From Here: Http://Www.Models-Resource.Com/Gamecube/Ssbm/Model/5337/ Edit: 08/15/19 - Ran Both Files Through Meshlab And Netfabb Basic. There Was Four Small Holes, But Nothing Breaking It Up Into Multiple Parts.
Statistics
Likes
225
Downloads
0