Tevo dual Z upgrade
Description
I Have Uploaded A Couple Of Pictures Of The Finished Duals. Only Difference Is I Used 3Mm Carbon Fiber For The Screw Brackets. Note: It Was Mentioned That There Are A Few Holes Missing, Sorry About That, Since I Didn'T Print Them I Didn'T Notice. Easy Fix For You Guys Though. :) I Have Had It Running For A Couple Of Months Now And It Just Runs Constantly With Minimal Adjustment Between Prints. This Is A Huge Improvement Over The Single Screw. Accuracy, Repeatability And Speed, I Run My Dit Printer Over 150Mm/S With Good Results. These Are Brackets For The Tevo Tarantula Dual Z Upgrade. Bom: 2 Screws 8Mm X 2Mm, I Used Kerk Motion 3/8" X .1" Lead W/Anti Back Lash. (Bottom Bkt Needs Mod For Other Screws/Nuts) You Will Also Need To Turn On End Of Screws To 5Mm X 20Mm With Flat. Use Hardened Shim Spacers .3Mm On Top Of Pully And Top Of Coupler/Collars. 2 20T Pullys. 2 Idle Pullys. 760Mm X 6Mm Endless Belt. 2 Couplers/Collars 5Mm Id 2 Bearings With Flange 5Mm Id 10Mm Od 4Mm Bolt With T Nuts For Frame Belt: Http://Www.Robotdigg.Com/Product/48/6Mm+Wide+760Mm+Gt2+Closed-Loop+Belt Pully: Http://Www.Robotdigg.Com/Product/145/Um+20+Tooth+2Gt+Pulley Bearring: Http://Www.Robotdigg.Com/Product/652/Flanged+Ball+Bearing+Mf105Zz Idle Pulley: Http://Www.Ebay.Com/Itm/172115773012?_Trksid=P2060353.M1438.L2649&Sspagename=Strk%3Amebidx%3Ait Collars: Http://Www.Mcmaster.Com/#Catalog/122/1214/=12L029H Screw Nut: Https://Prototypes.Haydonkerk.Com/Ecatalog/Lead-Screws/En/Lead-Screw-Zbxanr-037-0100-Bz00
Statistics
Likes
84
Downloads
0